Separate names with a comma.
The way I make sure that the two strings parallel on the outside of the frame is just before the last pull of the second string I check if at the...
That was a classic one! I was laughing a lot about it.. Completely incorrect call, yes. An example, when players should have asked for the...
To add to what @phihag said, the way I understand it, the term "unsight" mostly goes for not been able to see the shuttle and the racket of the...
Your condescending tone despite accusing me of of being aggressive is hypocritical. You think that because you are in company of the commentators...
You are the one trying to prove that there was a missed fault using the photo (ok, let's call it insane crop). I am just saying that I don't see a...
Just to add one more detail from the point of view of an umpire... Big part of the good umpiring is in fact avoiding giving faults when the first...
Sorry I was not more supportive of your suggestion.
Yes, the same argument. And when it is so close that there is almost no difference even IRS system cannot be absolutely perfect and there can be...
Sorry, I don't really see it as a problem in the system. Laws should be applied fairly for the benefit of the game and fairness. To say the truth,...
Yes, it's true umpire have to watch the receiver, but it is also responsibility of the umpire to call a foot fault if server stays on the line on...
I think you guys are doing too much out of it. I have seen this particular fault called many times. There was a famous game with Lin Dan where he...
double
I think it is important to remember that umpire should make a fault call only if he is absolutely sure there is a fault. We don't know if it was...
Haha, that's really terrible! However I am a little bit thankful to him as well since that terrible stringer unintentionally became a catalyst to...
Great story :). This guy must have been really really annoyed :D
Ah yes, that makes sense. On my gamma, load spreaders sit quite tight over the support column and badminton specific side supports work really...
By "nudged" do you mean tightened? I am a little puzzled why would it be necessary? All the supports are in compression when you tighten mains,...
You can also try this new method that is getting a bit more popular. Do not add extra on crosses at all but instead tighten lower supports by 2...
That's nice
No, sorry, stupid brain :eek:. Let me try again. I use the starting clamp to the right of the handle. I double pull then the first two mains and...