Hello , I broke my handle part on my yonex arcsaber 11 tour . After washing , sanding and degrease the shaft . For the new handle preparation , i drill for insert the yonex screw on the freecore. I prepare the bi composant epoxy glue for stick on the new handle. After 24 h this is my New yonex arcsaber freecore.
I see one seller on Aliexpress selling a non branded free core handle. I had a broken BS12SE with a freecore handle I tried to remove but was not able to.
I try this morning in tournament More hardest than thé yonex cap ( the shaft IS mort shorter ) Really good impressive
That aint right! Haha. The shaft supposedly suspended in the middle of free core shaft. Screwing it is not going to have the same effect as intended.
Yes you are right but the saft IS more shorter than in original wood also. This is not the original freecore on Victor but IS not wood handle grip an hybrid
I finally got my replacement handle in. I only got to hit with it a few times, still recovering from an injury. Based on a few hits I did, it has less vibration but there's not as much feel to my shots. Gonna try it again when I am able to start playing again
