Separate names with a comma.
I started playing Badminton around 1980-81 with colleagues at University. I must have had a talent for Badminton because soon I was playing...
Hi guys, I have been away for ages. I just wanted to comment on an enhancement I made to my Spinfire Flame turntable. The original axle mount was...
There are a few more racquets to add to this collection. Since I last posted here, a Satelite Brio, X-Feel Power, Satelite Synchro and today, a...
Actually I got some of these to try on my old Carbonex 15. They work better if you take the grommets out first, then put the grommets through...
One more thing, this was happening to some of my very old racquets - Yonex Carbonex 15 even with normal tensions due to age, the graphite frames...
One question - what string are you using that is causing this? I do know that using thinner strings means that there is more force (psi) on the...
Back in July this year, I helped a friend install these automatic clamps onto a Yonex crank machine. The rails were thinner than what the clamps...
kwun, Since it has been over a year now, what eventually happened with your Wise? I have had mine for just over 2 years, have strung 316...
stardalkar, Hi. I have been away from this forum for a while so did not see your post, but anyway - there should be a label next to each...
Good to hear that it isn't just mine.
Hi people! I don't string a lot of racquets, but do one or a couple at a time. I generally string the racquets the day before the racquet is...
As long as the supports are adjusted to be touching the racquet as flat as possible, i.e at right angles thus presenting the flat plastic onto the...
Anyway, it doesn't matter what it is called - all I can say is that I somehow found this knot either on the internet or from somewhere else, and...
My clients know that since I don't have a day job, that they can (if they wish, and in a hurry) bring the racquet in the morning and pick up later...
Try ebay and look for luggage scale or digital luggage scale. Usually only a few dollars. I have a couple that are made by WeiHeng and one looks...
As long as the dropweight bar stops in the near horizontal position, the tension should be fine. If it is up at an angle, the tension is high, if...
Ok - putting the string into the gripper problem. Most new machines have the linear string gripper - wind the string around the drum, then into...
The simplest way if you have any of the handheld digital luggage scales, is to attach strings to both ends, put one end in a fixed clamp or tie it...
The turntable should not be hard to turn. If it is, then chances are that the bearing has been done up too tight. I got a Spinfire Flame, and...