Separate names with a comma.
thanks for this measurements. I don't have a precise/consistent weighing device to convert theory to observation.
Yes, this thread I know, as that was the reason I did calculations in 2018?. Btw, sheet I used for calculation is available . Unfortunately, it is...
Thanks for pointing out the major flaw in the calculations. it gave me a chance to check it again. Infact full distance from gripper end to the...
Thanks for your replies. Yes, it is at school level. I should have clarified that the point I was looking for was "Hitting base first: With 30fps...
I was at a recent national school level badminton championships. (just to be clear, I was just watching it :) ). I could not figure, if this is a...
Thanks for the confirmation. I understand the solution and what they need to do. But it is not easy to convince someone who want to believe that...
I believe I understand this and just looking for confirmation on the understanding of rules. I have few beginners in the club who just started...
yes, that i am learning fast that this is also a field with subjective perspectives :)
ah, got it now. Bad reading :) But, in general it is preferred to tie-off in the nearest hole possible, unless we are following the standard...
For yonex 2 string pattern, how do we tie-off mains on B10? Isn't that the last hole from which string comes out? Or you meant something else? I...
Is this video already on BC somewhere or still in pipiline?
Fully agree with warranty constraints. These questions are of course out of warranty scenarios or for the daring ones :D Regarding Haribito, let...
Thanks Kwun for suggestions. Main point is not to take suggestions blindly, but use and adjust them based on your situation/scenario. The way...
I used the 1 piece Haribito 72 holes pattern. I agree that the outside of racket looks really neat and clean and less long passes between holes. I...
Finally 2 projects came together. To make grooves to avoid sliding of the machine on the top. 2nd to make a simple cardboard based drawer for the...
He he, Yes, I try t make sure of that. Otherwise it will fall on my foot :D. But I will try to make something that the foot are not on top of the...
Don't have any place and probably table for my machine(yet). It was really hard for back and tiring working on the old setup. managed to build a...
Thanks, will try. I think with this discussion we (atleast I) learned something about the design and its effect on dropweight machines. Not sure...
Ha ha. I believe you. I was going mad as to what is wrong here :D. Glad you took off that extra weight. I am sure you will enjoy it now.
Well, I do not have any gadgets to measure pings or pull (yet :) ). But, I think straight gripper offers ease of use, so it should be preferable....