Separate names with a comma.
I think the new position of the 88D is probably closer to what I think the 88D is. Probably closer to VTZF2 in terms of head heaviness and hard...
I've merged the Astrox chart (green) with the full matrix chart (grey) based on the centre cross and the eccentric circles. Probably they are not...
[ATTACH] [ATTACH] Some photos of the new racquet and stringing up the racquet last night. I would say the 4U version is great for both singles...
I've just sold my AX88S 4U. Even though it was a really good racquet but it was just lacking a bit in smashing power. I was considering either a...
I've gone through a period of trying many strings and tension combinations over the years as I string my own racquets. I really like the Aerobite...
Z-force II is a very stiff and very demanding racquet. It is very powerful but it has a smaller head and a smaller sweet spot. Therefore, it is...
I think the VGlanz is the most under rated racquet. This is currently my main racquet for both singles and doubles. I'm an intermediate-advanced...
The 3U version is on special for AUD$179.95 [MEDIA]
Lin Dan Exclusive II
You will need to tighten the "first" through string before closing the knot with the "second" through string.
I tried the Toshi knot on my last stringing job, but I think I've stuffed it up and couldn't tighten it properly. So, I've made a practicing...
I got my Z force 2 LD a few days ago. It looks great.
These look like the ones they sell at Tennis Warehouse in Australia:...
Thanks for that. I want to polish the bottom of the clamp bases and also the rails to make them as smooth as possible for the ultimate glide.
Have you polished the sliding surfaces of the clamp bases? If so, can I ask what you used? Thanks
Once you have tightened the bottom screws, does the adjustment screw turns either clockwise or anticlockwise? If it doesn't turn at all, then I...
If it became permanently stuck, that means you need to loosen up the adjustment screw even more. So, loosen up the adjustment screw until the...
Tighten the 2 screws underneath with the lever in UNLOCKED position. Make sure you tighten the 2 screws very tight. After this, if you may find...
I had the same problem initially. What you need to do is first remove the black cap on the side and loosen the adjustment screw with an Allen key....