Separate names with a comma.
As far as I can tell, there's nothing wrong with them. I just thought there might be some better/newer ones on the market. Maybe I just like...
I'm looking up get new clamps and bases for my Gamma X-ST, I have had my current ones since I bought the machine 7 years ago. What are the...
Anyone else watching on BT Sport and think the commentary during ENG-JAP is not very good? Where are the likes of Gill & Steen etc?
The Yorkshire League has a similar set up and is very highly regarded 1MS player 1WS player 2MD pairs (play both pairs) 2WD pairs (play both...
I first heard about reversing the final 3 crosses last summer when Tim did a Zoom with Paul Stewart which is still on Pauls Youtube channel. I...
Yes that's what I thought, didn't make sense to me!
Thanks to both your answers! I have it relatively close so that's good and I definitely will be using constant pull. It was one of the reasons I...
I have recently purchased a new WISE for my Gamma machine and have a few questions as it is my first time using an electronic tension head. I hope...
So unless I'm mistaken, if the Yonex stringing team are asked to do a 30lb restring when just 1 tension is given (ignoring pre stretch) for a...
I was calibrating my Gamma X-ST (X-Stringer) with the WISE Electronic Calibrator and with that, I was pretty happy I had managed to get it to...
Update: No gap between frame and grommet! This seemed to work, I have a couple more to do tomorrow so fingers crossed found the solution....
I have just finished stringing a racquet trying this and the amount it came away was certainly smaller & went back flush against the frame 2...
Will do, thanks
I'll check the tightness. I do them all finger tight, just enough so I don't have to apply pressure when turning to tighten
Yes that's right. I always do 3 mains to the right first then 3 to the left before alternating after every pull with a double pull at B10 for...
I use a Gamma X-Stringer ST, it is happening on all racquets I get, at any tension (+2lbs on crosses) but is more pronounced at a higher tension...
I seem to be running into an issue with my bottom left side support whilst stringing in that when I get about halfway up the crosses, I can see a...
I was clearing out a few boxes and came across a half used set of BG80 that I didn't know I had, I don't know how long it was in the box for so...
When stringing I am trying to avoid "crossovers" when threading into the shared grommets at the bottom of a racquet, yet somehow keep finding the...
Thanks for your reply, yes it only happens at the top no matter which way round I mount the racquets.